Comgrow Dryer Tower

I sliced the top of martintc_max's filament dryer box riser and then designed a sturdy 450mm tower to go underneath it. The dryer was getting my desk very hot and I had trouble running filament from that lower position. This raises it enough so that the front filament ports in the dryer are above the top bar of the A1. I used PCTG on the top section that the dryer sits in because I was worried about it softening with PLA. With that said, the printed part doesn't seem to get very hot at all and PLA will likely work fine. I opted for dowel-style connectors so that I could test out different sizes and so that a broken connector wouldn't necessitate a long reprint.