Comix-35 DIY Computer Clone 3D Case (COMX-35)

This is a 3D case for the COMIX-35 computer (That is a clone of the COMX-35). The current model can be printed on something similar to CR-10 S5 but I will return with a version that can be printed in parts for smaller printers. Please note that there is no provision for expansion cards on this design. The PCB holders are there as I didn't want to make any holes on the four PCB corners.

I have designed the case without a hole for the on/off switch in order to honour a very specific Sir :-).

The screws that can be used with the case are:

M3x16mm for all screws accessed from the bottom of the case
M3x25mm for the three holes at the back of the case
2x5mm for the PCB holders as my PCB has no screws

There is an additional file (base_for_show.stl) that can be used in pairs to fit under the computer and offer a more efficient typing position so you can type in that dissertation of yours. It also makes the system look "more sophisticated" when in show mode :-)

The following P