Command Center Panels - Magsafe Pannel

Magsafe adapter (https://www.amazon.com/dp/B0DLP157QH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) for a desk command center/panel system. This one has one side cut out to accept 5x3 mm magnets but they will only fit in with a solder pushing them in which helps to secure them. Hexagon cut outs on the side to run wires through them. Inside there is a cutout to accept a 90 degree usb c adapter (https://www.amazon.com/dp/B0B77CJD7T?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1). I used:Gyroid infill pattern with 20% infill 6 wall loops6 top shell (optional Octagram top pattern as I like the way it looks)6 bottom shells6 mm brim (as I printed in PETG in a really cold garage in the winter)0.24 mm layer heightreally slow speeds for high quality finish20 mm/s initial layer25 mm/s initial layer infill40 mm/s outer wall60 mm/s inner wall60 mm/s sparse infill50 mm/s internal solid infill120 mm/s travel speed50 mm/s bridge230 mm/s gap infill70 mm/s support40 mm/s support interface