Thingiverse
Command Strip Headphone Stand
von domdanial
19
Downloads
11
Likes
1
Makes
Didn't like many of the other designs I found, so I made my own! Wanted a design I could remove without causing too much damage.
Its fitted for two of the smallest double adhesive "Command" strips(13mm x 16mm), and has held for a month on the side of my desk. Cut off the little pull bit.
Overall size is about 6.5cm wide by 5cm deep.
Its fitted for two of the smallest double adhesive "Command" strips(13mm x 16mm), and has held for a month on the side of my desk. Cut off the little pull bit.
Overall size is about 6.5cm wide by 5cm deep.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!