Thingiverse
Commander rear protector with mudgard
von danielmk3333
14
Downloads
5
Likes
1
Makes
Design these parts with the protection of the plastic parts in mind and support in the front or back.
It is printed on eSUN TPU hardness 95 with a 15% to 13% infill.
You must fix it with adhesive velcro or double-sided tape.
I hope you find it useful.
It is printed on eSUN TPU hardness 95 with a 15% to 13% infill.
You must fix it with adhesive velcro or double-sided tape.
I hope you find it useful.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
