Commander X16 or Micro ATX Computer Case

Commander X16 3D printed case.

Printed with Ender 3 V3 SE with PLA.

Case size is 254mm x 254 mm x 70 mm

Assembled with Dogbone dutchman, and can be glued with CA or Hotmelt
Recommend gluing top parts together.
Top plate uses 5mm tall dogbones to connect to top plates.
Case is too large for many printers so in four parts.
Full case STL provided for view but not tested for full size print.

Print 1 of each case part
Print 1 of each top part
Print on set of dogbanes 8x5mm and 4x3mm
Print 3 Side badges
Print 1 top plate
Print 1 backplate (optional)

Use supports on case parts.
Top plate is rounded over, so use support of brims based on your computer.

use #4 5/8 or 3/4" wood screws to mount board to case

16mm push button for power switch
12mm push button for reset switch
Various options on Amazon for switches
one 3mm screw, washer and nut for attaching back plate, will need to drill mounting hole in case
Button Badges are optional, can be just held in pl