Commodore 1702 control door

I re-combined the two halves of the door design for printing on large printers like the Creality CR-10 (which is what I use). I had to print it at a 45 degree diagonal angle to make it fit but the results came out very good. I used eSun PETG for the material, gave it a light sanding and sprayed it with Krylon Colormaster Matte Griege. The PETG is very strong and flexible so the clips will not snap off like PLA.

I HIGHLY recommend you measure your 1702 monitor since it is highly likely that yours will not be the exact width of the STL file and will need to be scaled in your slicer program. Mine ended up being approximately 99% scale, but yours might not be.