Thingiverse
Commodore 64 (1541) - SD2IEC Mini Enclosure
von bruno
2
Downloads
10
Likes
0
Makes
Enclosure for SD2IEC Mini (a Commodore 64 1541 Disk Emulator).
like this one: https://www.faszinationc64.de/SD2IEC-SD-Kartenleser-Mini
When soldering the kit, make the LED's 1cm high (the metal pins measured from the PCB to the LED plastic).
Print the upper part without support material (that worked best for me. otherwise it can be difficult to remove the support in the shafts and smaller parts).
There are holes/shafts foreseen to put small screws but they are probably not needed, the two parts snap and stick pretty well together.
like this one: https://www.faszinationc64.de/SD2IEC-SD-Kartenleser-Mini
When soldering the kit, make the LED's 1cm high (the metal pins measured from the PCB to the LED plastic).
Print the upper part without support material (that worked best for me. otherwise it can be difficult to remove the support in the shafts and smaller parts).
There are holes/shafts foreseen to put small screws but they are probably not needed, the two parts snap and stick pretty well together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
