Thingiverse
Commodore 64 Power Switch Mount
von ThatKert
6
Downloads
29
Likes
0
Makes
Version 2: This was updated to allow room for the power plug and joystick 2 to fit correctly. It seems to work better.
Go ye forth and play thy Questrons.
This is a mount for a Heschen Rocker Switch ON-Off DPST 4 Terminals 16A 250VAC Black 2Pack on a Commodore C64C. I needed to replace the power switch, and the switch model that I preferred is larger than the hole from the original switch. I created this mount to allow power lines from inside the C64 case to reach the switch on the outside. The mount snaps into the C64 power switch opening, the wires are fed through, the switch is inserted to the open end, and then a cover is snapped onto the top.
Go ye forth and play thy Questrons.
This is a mount for a Heschen Rocker Switch ON-Off DPST 4 Terminals 16A 250VAC Black 2Pack on a Commodore C64C. I needed to replace the power switch, and the switch model that I preferred is larger than the hole from the original switch. I created this mount to allow power lines from inside the C64 case to reach the switch on the outside. The mount snaps into the C64 power switch opening, the wires are fed through, the switch is inserted to the open end, and then a cover is snapped onto the top.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
