Thingiverse
Commodore Amiga 3-button Joystick
von TrashyMG
66
Downloads
50
Likes
0
Makes
This is a 3-button joystick I designed specifically for my Amiga, it seems only few games support the third button, but handy for the ones that do, like ADOOM and such. This remix I kept the basic shape, but shrunk down for the smaller amount of buttons and to fit on my 150mm x 150mm print bed. I have entirely redesign the bottom portion to fit the top.
I'm using the small Joystick and Arcade buttons from Adafruit, but you can likely source these from elsewhere.
https://www.adafruit.com/product/480
https://www.adafruit.com/product/473
The top lid in the original design is held by M4 x 10 bolts and hex nuts and I kept that in my this design. but for my build, I found some self taping screws that work just as well. The cable I used is fairly thick, if you use a thinner cable, you may need to change the hole the cable passed through or use some other method to ensure that the cable won't move if tugged on. It's possible you can find a plastic cable strain relief grommet that w
I'm using the small Joystick and Arcade buttons from Adafruit, but you can likely source these from elsewhere.
https://www.adafruit.com/product/480
https://www.adafruit.com/product/473
The top lid in the original design is held by M4 x 10 bolts and hex nuts and I kept that in my this design. but for my build, I found some self taping screws that work just as well. The cable I used is fairly thick, if you use a thinner cable, you may need to change the hole the cable passed through or use some other method to ensure that the cable won't move if tugged on. It's possible you can find a plastic cable strain relief grommet that w
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
