Thingiverse
Commodore LED Logo
von makerbotstuff
69
Downloads
58
Likes
1
Makes
Edit:
After being advised on the difficulty printing multiple items in 'Vase Mode', I've now added a Single Bar STL and the 'Chicken Lips' singular STL's too.
Thanks for the heads up Kinetics24.
This is an illuminated Commodore sign using WS2812B addressable LED's.
My choice of controller for this project is an ESP32 using the WLED software.
Alternatively you could use any other controller such and Arduino, Arduino Nano etc.
I've stuck with the ESP32, as it's so easy to use and customize.
The Chicken Lips Logo and the Colour Bars both have passthrough holes for feeding the continuing wires to the next LED's. However, there are no holes in the bases of these models as that will be down to you where you want to feed the wires out of the back of your models.
I'll not lie, this project is a pain to complete. It's taken me roughly an hour to complete the soldering for each letter. An hour and a half each for the letter 'M's and well over two hours for the colour bars. The Chicken Lips
After being advised on the difficulty printing multiple items in 'Vase Mode', I've now added a Single Bar STL and the 'Chicken Lips' singular STL's too.
Thanks for the heads up Kinetics24.
This is an illuminated Commodore sign using WS2812B addressable LED's.
My choice of controller for this project is an ESP32 using the WLED software.
Alternatively you could use any other controller such and Arduino, Arduino Nano etc.
I've stuck with the ESP32, as it's so easy to use and customize.
The Chicken Lips Logo and the Colour Bars both have passthrough holes for feeding the continuing wires to the next LED's. However, there are no holes in the bases of these models as that will be down to you where you want to feed the wires out of the back of your models.
I'll not lie, this project is a pain to complete. It's taken me roughly an hour to complete the soldering for each letter. An hour and a half each for the letter 'M's and well over two hours for the colour bars. The Chicken Lips
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
