Thingiverse
Community Mailbox Security kit
by Nscale_toni
5
Downloads
8
Likes
0
Makes
Our mailbox kept getting broken into, so I created these deterrents to slow the boneheads down (or at least make them look elsewhere)
Our mailboxes have several different lock bezels on the outside, and at least two different styles of lock bodies on the inside.
So far this has been working well for the past year
Print using PETG with 50% infill for temperature resistance & sturdiness.
Lockramp1 - is meant to be glued around the lock bezel to make it harder to grab the part with a set of visegrips. I used E-6000 glue to hold our in place.
Lockbody - is designed to fit over the lock on the inside & engage the rib of the tumbler cylinder & wedge against the inner edge of the door to prevent rotation.
Our mailboxes have several different lock bezels on the outside, and at least two different styles of lock bodies on the inside.
So far this has been working well for the past year
Print using PETG with 50% infill for temperature resistance & sturdiness.
Lockramp1 - is meant to be glued around the lock bezel to make it harder to grab the part with a set of visegrips. I used E-6000 glue to hold our in place.
Lockbody - is designed to fit over the lock on the inside & engage the rib of the tumbler cylinder & wedge against the inner edge of the door to prevent rotation.
Nscale_toni also publishes on
17 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
