compact adapter for side extruder support mount

Once you have the Side Extruder Support up and running, and you have to place the printer in a smaller enclosure you can use this adapter to mount the original extruder-support-mount to my adapter in order to move the extruder down, and I also tilted it a little that the overall width was reduced.
Please take care (!): the cable length of the original filament sensor is too short to reach this new position (because my Octoprint can not use the filament sensor I have it simply not in use) but I will upload a second version as soon as I need to install the filament sensor.


https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.

A M3-.50 nut is required.