Slicer Discord
Compass Design – 3D-Druckmodell von GrabCAD GrabCAD
Parasolid

Compass Design

46 Downloads
38 Likes
0 Makes
Zum Modell
[So why does the needle always point north? I researched it for you, friends; The fact that the needle constantly points in the same direction is due to the fact that there is a force on the earth that pulls the needle. The earth is like a huge magnet, one end of which extends to the north and the other to the south. The Earth's magnetism causes the compass needle to rotate towards magnetic north (the north pole of the magnetic field).] A compass is a device that shows the cardinal directions used for navigation and geographic orientation. It commonly consists of a magnetized needle or other element, such as a compass card or compass rose, which can pivot to align itself with magnetic north. Other methods may be used, including gyroscopes, magnetometers, and GPS receivers ... Compasses often show angles in degrees: north corresponds to 0°, and the angles increase clockwise, so east is 90°, south is 180°, and west is 270°. These numbers allow the compass to show azimuths or bearings which are commonly stated in degrees. If local variation between magnetic north and true north is known, then direction of magnetic north also gives direction of true north. Among the Four Great Inventions, the magnetic compass was first invented as a device for divination as early as the Chinese Han dynasty (since c. 206 BC),[1][2] and later adopted for navigation by the Song dynasty Chinese during the 11th century.[3][4][5] The first usage of a compass recorded in Western Europe and the Islamic world occurred around 1190.[6][7] (Quoted from Wikipedia)
Kategorie
Parasolid
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STEP, STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen