Component Cooling Anycubic i3 Mega

This component cooler is intended for use with the original radial fan.
The existing one-sided air distributor can easily be exchanged for this one.
You only need two M3 nuts. There is also the option of sawing off the lower part of the existing component and using the rest as a nut.
The cooler contains an air control system so that air can still reach the opposite side. I think it works very well.

Since the component is attached near the hotend, it should be made of heat-resistant material such as ABS or ASA can be printed.

Have fun trying.

Many greetings Andre