Thingiverse
Component Tester Box
door wimberleytech
11
Downloads
8
Likes
0
Makes
This is YACTB (Yet Another Component Tester Box). I was inspired by wavexx who posted one recently. My tester is different than any other I have seen on TV so I had to design my own. I liked the philosophy of wavexx so I adopted some of it.
My own innovation was to make the battery accessible without removing the board. The battery is 'attached' using a neodymium magnet. The rectangular pocket is there to fit my magnet. I was going to use two (thus the length) but decided one was enough.
I love these little testers. Small, fast, reasonably accurate, and cheap! Hey, not up to my Fluke, but hey, my Fluke is three times the volume and no ZIF socket.
My own innovation was to make the battery accessible without removing the board. The battery is 'attached' using a neodymium magnet. The rectangular pocket is there to fit my magnet. I was going to use two (thus the length) but decided one was enough.
I love these little testers. Small, fast, reasonably accurate, and cheap! Hey, not up to my Fluke, but hey, my Fluke is three times the volume and no ZIF socket.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
