Compound Bow Center Shot Laser Alignment Tool

This assembly is used to help set the center shot on a compound bow.
To complete this assembly the following is needed:
Hardware:
4 - 10-24 countersunk head x 1.5" in length
2 - M6 Washers
1 - M6 Nylock Nut
2 - M6 Standard Nuts
2 - 10-24 Nuts
1- M6 Hex Head bolt 60mm to 70mm in length
Printed Parts:
1 - Riser_Mount.stl ( 1 nut is inserted during this print)
1 - Laser_Clamp_Outer.stl
1 - M6 Knob ( 1 nut is inserted during this print)
1 - Laser_Clamp_Base.stl (2 nuts are inserted during this print)
2 - 10_24_Keeper_Washer.stl
4 - 10_24_Knob.stl
You will also need to supply a laser pointer. I recommend a decent laser pointer and not a cat toy type laser that costs a few bucks as from testing the alignment\lens on those are not good.
A few of these components require the nuts be inserted during the prints by pausing @zpos and then inserting the nuts and continuing the print. I would use a gcode viewer to find the last layer height the b