Compressed air euro coupling tool mount

This tool holder is able to hold a tool for use with compressed ait not by the deattached connector, like other holders do, but rather on the standard euro coupling, which allows for tool usage without having to disconnect the tool while not using it to store it properly.

I'm using my design for a blow gun, but I assume that it is strong enough to hold oder pneumatic tools as well.

I do NOT recommend using the holder to attach your tools to the coupling, as it might break. However, I uploaded my Fusion360 source file so you can beef it up, if you want to.

The regular mount fits the coupling lose enough that you can take it out with ease, but there is quite a bit of wiggle-room. I created a "tight" version, which should allow for less tolerance and thus will hold onto your tool a little bit better.

Diameter for the coupling on the regular version is 30mm, 28mm on the tight one.

Diameter of the mounting hole is 5.4mm