Condensate Trap

This is a TPU Condensate Trap designed to fit over 1 inch and ¾ inch PVC pipe and attach with hose clamps. Intended to use on Roof Top heating/cooling packaged units in freezing climates. I left the inlet side extra tall to leave room to slide the trap up to unhook the outlet, then slide down to remove. Cut the inlet shorter if needed. Mostly vertical walls, mild overhangs. No support needed, no brim needed. 1 bridge prints internally on a wall, is deep enough that if the start of that wall prints poorly, it should not affect performance. Printed on a P1S, .4 nozzle. Top and door open. Added my profile for Overture TPU with settings based on Bambu TPU for AMS. Recommend printing without AMS, but I was able to get the AMS to work with this filament. Use the measure tool to select ID of the inlet and scale to custom size as needed. Scale vertically as needed without affecting the pipe size.