condensed ifixit tookit box

This is a toolbox for the Ifixit pro toolkit to make it more portable to fit in a small bag.
it requires that you print the base in TPU and is suggested that you print the lid in PLA (8 neodymium magnets are required as well)
link to magnets
https://www.kjmagnetics.com/proddetail.asp?prod=D22
these are 1/8" by 1/8" cylinders and must be aligned with the correct poles (superglue to lock in place)

!!don't heat the magnets to melt them in place or they will lose strength this can be done to remove them in the event you got the poles wrong but I suggest you buy a full set of spares.

to remove bits use the handle and twist and pull after inserting. to replace bits slide them in with handle and pull straight out.