Thingiverse
Cone Hub for SPANNERHANDS Spool System
door mmdoogie
70
Downloads
32
Likes
0
Makes
I loved the look of the [SPANNERHANDS Spool System](https://www.thingiverse.com/thing:2119644/) enclosed spool-holder, but wanted something with an adjustable / universal hub to fit all of the different brands of filament I am playing with. I designed and printed this to fit the large 1kg spool box and use the ubiquitous 608 bearings. The cone fits spools with a hub diameter between 24mm and 60mm. The width of spool that will fit inside the enclosure varies with hub diameter, from about 83mm with a 60mm hub down to around 47mm for a 24mm hub.
Parts needed:
* Two prints of the Cone Hub
* Two prints of the Bearing Holder
* 100 mm length of M8 threaded rod
* Two 608 bearings
* 5 M8 thin nuts
Assembly:
1. Place a drop of superglue on the outside edge of each bearing and press them into the bearing holders.
2. Place a drop of superglue on the outside edge of 4 of the nuts and press them into the four recesses in the cone hubs.
3. Thread the last nut onto the rod with enough
Parts needed:
* Two prints of the Cone Hub
* Two prints of the Bearing Holder
* 100 mm length of M8 threaded rod
* Two 608 bearings
* 5 M8 thin nuts
Assembly:
1. Place a drop of superglue on the outside edge of each bearing and press them into the bearing holders.
2. Place a drop of superglue on the outside edge of 4 of the nuts and press them into the four recesses in the cone hubs.
3. Thread the last nut onto the rod with enough
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
