Configurable Ruler Gauge/Limit Block (Parametric)

If you would like a gauge or limit block for your ruler, then this print may be for you. FeaturesThe model is easy to operate and will not move on the ruler as it is clamped into position. This allows accurate placement on the ruler.As long as the housing is a neat fit to the ruler, the model will remain firmly in position once clamped. It can be configured for virtually any size of clamp on rectangular or square material using the Fusion 360 file supplied. There are 4 parts to the print:HousingClampLeverTemplate (print this first to check for correct fit - more details below)Hardware NeededA metal shaft or screw is needed for the hinge due to the pressure when the model is clamped onto a ruler.The print profile supplied for a 25mm x 1mm 300mm long ruler has 3.2mm diameter holes for the hinge to suit an M3 bolt.The model works well with the brass or stainless steel dowel pins found in Maker's Supply.If using screws for the hinge shaft, the length of the screw(s) will depend on the