Thingiverse

Conrod Balancing Jig

by brobano

4 Downloads

11 Likes

0 Makes

Made this jig as i didnt want to spend $500 on an actual jig. was able to get my conrods balanced to withing .05g. It can be a little tricky so some patience is required for those ultra fine numbers. Need to get bearings to suite, 4x 8mm I.D., 14mm O.D. 4mm width & 2x 14mm I.D., 22 O.D., 7mm width

This was for my Audi b5 s4 the top left BE wheel is 57mm intended for this car and made additional in 1mm increments.

Enjoy!

4 cylinder Audi BMW connecting rod conrod engine mercedes mitsubishi Nissan toyota V6 engine v8 engine

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format

STL

Material

Post-processing

Hardware

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Conrod Balancing Jig

Similar Models

Add to Collection