Thingiverse
Electronics
Go to Model
Construction Block Raspberry Pi Zero two piece
60
Downloads
40
Likes
0
Makes
*** Updated ***
Two piece case for raspberry pi zero, ten by five pips long by wide, one block high. Two designs for the top and bottom, one with and one with out cutouts for the forty pin gpio.
I have not had a chance to print this out yet, as my printer is off line.
** update **
Corrected the spacing of everything and added features on the underside to be more consistent with the construction block system I am trying to be compatible with. Added sketchup model that was used as well as a render of what the result is with my Raspberry Pi Zero version 1.3 model in place.
Creative Commons Non Commercial Share Alike. Commercial license can be negotiated.
Two piece case for raspberry pi zero, ten by five pips long by wide, one block high. Two designs for the top and bottom, one with and one with out cutouts for the forty pin gpio.
I have not had a chance to print this out yet, as my printer is off line.
** update **
Corrected the spacing of everything and added features on the underside to be more consistent with the construction block system I am trying to be compatible with. Added sketchup model that was used as well as a render of what the result is with my Raspberry Pi Zero version 1.3 model in place.
Creative Commons Non Commercial Share Alike. Commercial license can be negotiated.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
