Control unit for 3DPandoras

NOTE: Discontinued !!!
I'm going to start from scratch next month probably 24-02-2020. I can take a printer that has been non-productive for 5 years home to get it to work.

See the newer project...


This is the power control unit.

- main power
- upper LED light
- lower LED light
- USB to PC
- USB port for USB drive
- Mysterious button...

UPDATE 2017-09-14
Minor ajustment to ports on the side and 3,5mm additional extrude-cut on the back USB port. Placement notch for PCB removed because it only creates problems with webbing due to the small size. (even when printer with 1,75mm)