Controller & Headphone wallmount with Cableholder

A remix of the original design witth some added height and and cable holderWall mount/stand for an Xbox (or similar) controller, and headset. Holes are sized for #8 wood screws (which I believe should be equivalent to 4mm wood screws if you don't use freedom units). Intended to be printed on its side, but people have been having success printing on the back as well. Layer orientation will be less optimal if printed on its back, but for the loads it's intended for that shouldn't be a problem. Use whatever structural print profile works best on your printer, I did 3 walls, 15% infill, 0.20 layer height.