Thingiverse
controller stand(truck styling)
von stephen_w
1
Downloads
4
Likes
0
Makes
I designed a funny controller stand，it is a truck styling. I will design some application models of vehicles shapes, hope you like it.
This model was printed using PLA. (fill in 15%，using a lower layer hight (0.15/0.2mm))
Special Suggestion
as shown in the picture, The Truck head need to support.
This model was printed using PLA. (fill in 15%，using a lower layer hight (0.15/0.2mm))
Special Suggestion
as shown in the picture, The Truck head need to support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
