Converse Chuck Taylor for Ghosties!

This is a dual filament / colour Converse Chuck Taylor sneaker set for the very cute and popular Ghosties! model. Print Settings Print the sole in whatever filament you like and the top in perhaps some more colourful filament. I recommend using a 0.40 mm nozzle and a layer height of 0.20 mm or less for best detail. Print the parts in the directions I have placed them. I recommend using a brim for additional bed adhesion as the bottom area of the parts is quite small. Once printed, break off the support from the bottom part and sand it slightly if needed. Installation To install, first insert the toe “tab” on of the top of the shoe into the slot of the sole then press the two parts together. It snaps in place, you should not need any glue. Next, insert the shoes into your printed Ghostie of your choice, there are a bunch of different designs to choose from at the original Ghosties! design page: All done! The Ghostie! below was printed in eSUN ABS+ Luminous Green and the sneakers printed