MakerWorld
Hueforge & Lithophane
Go to Model
Cooler Energy
5
Downloads
7
Likes
4
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThis print uses 3 unique filamentsSwap Instructions: Start with Black At layer #11 (0.96mm) swap to Jade White At layer #18 (1.52mm) swap to Red for the rest.(My white fillament was wet but the print is so easy, it still managed to print it ..you can tell by the dots on the photos lol )
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
