Thingiverse
COOOL ICE STRAW!
por 5KTURTLE5
1
Descargas
2
Likes
0
Makes
This here is the one of a kind, super cool (pun intended) ice straw!!! The ice straw itself is a massive and above average over 7 inches long! Remember, this is just a straw nothing else.
How it works is you first print out the mold and the cap in some sort of flexible filament, (I used TPU). Then cut some nonprinted filament off the spool and thread it threw the mold and cap (the seal should be just tight enough to let no water threw). fill it with water, cap it, stretch the filament straight, and let it freeze! once its fully froze, run some hot water over it and squeeze it out from the back. then get to sucking.
would love a tip if you can spare it!!!(:
How it works is you first print out the mold and the cap in some sort of flexible filament, (I used TPU). Then cut some nonprinted filament off the spool and thread it threw the mold and cap (the seal should be just tight enough to let no water threw). fill it with water, cap it, stretch the filament straight, and let it freeze! once its fully froze, run some hot water over it and squeeze it out from the back. then get to sucking.
would love a tip if you can spare it!!!(:
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!