Thingiverse
Copymaster 500 Z Limit Switch Bracket
by HughMann
3
Downloads
2
Likes
0
Makes
After adding a 4mm thick glass, and insulation to the bottom of the print bed, I was really struggling to get the bed low enough to stop the nozzle hitting the glass, so I've redesigned this part to allow for a 4mm adjustment of the z-axis limit switch.
You may have to use smaller screws or enlarge the holes for the limit switch screws as depending on the tolerances of your printer, the holes may print smaller than they are on the model.
You may have to use smaller screws or enlarge the holes for the limit switch screws as depending on the tolerances of your printer, the holes may print smaller than they are on the model.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
