Thingiverse
Corbin 59C2 key blank
by Hassan_Helal
52
Downloads
37
Likes
0
Makes
I needed a spare key, but I was too lazy to leave the room.
I am not sure if this really counts as a blank; since the width of the key was taken from a key that was cut, and I could not find any specs on this type of key.
The one with the cut tip is based on the key I had, you might need a different length.
You will need to print it flat with build plate supports. 0.1mm resolution is recommended,
The fit was perfect for me. Just remove the supports, no sanding required.
Included formats: SLDPRT, STEP, STL
I am not sure if this really counts as a blank; since the width of the key was taken from a key that was cut, and I could not find any specs on this type of key.
The one with the cut tip is based on the key I had, you might need a different length.
You will need to print it flat with build plate supports. 0.1mm resolution is recommended,
The fit was perfect for me. Just remove the supports, no sanding required.
Included formats: SLDPRT, STEP, STL
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
