CoreXY Power Carriage

This is the carriage I designed for my custom coreXY printer. It features a compact design, aimed to take advantage of HIP´s high temperature melting point to minimize the spacing between the block and the carriage plate thus allowing me to use an original vulcano block and heat break from e3d combined with a regular mk8 direct drive, and achiving very similar performance as my original titan aero that I have in my other printer.
Notice the following, the spacing between the smooth rods is 59mm from center to center, that can be adjusted in Fusion 360.
If you want to use a clone heat break, notice that you will need to print "Lower Guide For Clone Barrel.stl" to match the 6mm end.
If you are using an original e3d heat break, you may need to expad your mk8 aluminum plate threaded hole from 6mm to 7mm, this can be achieved with a 6mm drill bit and a 7mm male hole maker (dunno the name in english). Either way, you should make some small dents in the upper part of the thread to stop the