Corner brackets for Ender 4

Thought my Creality Ender-4 was a little wobbly and got a little Z noise because the bed z-rods wasn´t supported enough and the hole thing wasn´t as stiff as I wanted, especially for large prints at higher speeds
First I printed this thing https://www.thingiverse.com/thing:2572407 and it works great, but it just wasn´t quite enough

So I designed these corner brackets and they work magic.

they might fit the Ender-5 too and other printers with the same extrusions

You´ll need a lot of 5mm screws and T-nuts

Bracket 1 is for the corner without the little metal bracket inside the extrutions.
Bracket 2 is for all the corners where the metal bracket is in place as in all the top corners