Thingiverse
Corner Clamp
by Braunbaer
580
Downloads
423
Likes
0
Makes
Test.stl bevor print the hole thing!
- I made a Test print with the thread horizontal and it does work but you shoud test it by yourselfe with the Test.stl and screw them togheter.
- In my case it was a bit hard but after a bit of rotating i does work and iv not u can still poor a liitle hot water over it try it severel times but be careful with melting.
- I print it with dimesion oif 75% of Original
- I used Supports with roof and 0.2 mm distanz to top 0.3 mm Sideways
Print with 20-30% Infill Gyroid
- 4 Perimeters gives the structure more stability than higher Infillrate
If you like my work a little Tipp is much appreciated
- I made a Test print with the thread horizontal and it does work but you shoud test it by yourselfe with the Test.stl and screw them togheter.
- In my case it was a bit hard but after a bit of rotating i does work and iv not u can still poor a liitle hot water over it try it severel times but be careful with melting.
- I print it with dimesion oif 75% of Original
- I used Supports with roof and 0.2 mm distanz to top 0.3 mm Sideways
Print with 20-30% Infill Gyroid
- 4 Perimeters gives the structure more stability than higher Infillrate
If you like my work a little Tipp is much appreciated
Braunbaer also publishes on
40 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
