Thingiverse
Corona Faceshield
von theonly1v
7
Downloads
5
Likes
0
Makes
- push a pointed object (e.g. nail) through the holes on the side to prevent the sheet from sliding out
- the foam can be attached by double-sided tape
- the brackets need to be printed twice
- the main part has to be printed upside down
- I recommend rounding off the corners of the sheet for more comfort
- additionally required materials:
- piece of foam (e.g. from thermal mat)
- flat elastic band (width 20mm)
- plastic sheets (230 x 330 x 0.4 mm)
Good luck fighting covid-19!
- the foam can be attached by double-sided tape
- the brackets need to be printed twice
- the main part has to be printed upside down
- I recommend rounding off the corners of the sheet for more comfort
- additionally required materials:
- piece of foam (e.g. from thermal mat)
- flat elastic band (width 20mm)
- plastic sheets (230 x 330 x 0.4 mm)
Good luck fighting covid-19!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
