Corvette Light Box

Corvette Lightbox I printed the front plate separate from the body so if an issue should develop a lot of filament won't be wasted. There really shouldn't be any issues with this as I printed it twice without any issues. I printed this on my X1C. When you download this MAKE SURE TO TURN ON THE PURGE TOWER. Bambu would not allow me to up load it with the purge tower. It said it was off the plate which it wasn't. The back body section I made so that you can hang it on the wall or mount it on the optional stand with some glue. As you can see in one of the photos I wrapped the led light strip around the inside twice and then I cut off the few remaining inches. I also used my hot glue gun to add a little bit of glue to the light strip just incase the adhesive on the light strip didn't hold after I put it all together, I made the light box with notches on both sides so that the face plate will align correctly. The face plate is very snug so you may have to bow it just a little to get it to p