Cosplay Helmet Stand

Hi all! I scoured all the websites with STLs looking for a simple display for my helmets as I don't want to hang all of them to my wall and eventually use them on top of shelves. There's a plethora of displays stands available everywhere but most used too much filament or just took forever to do so I went ahead and headed over to Fusion and designed one for myself that uses very minimal filament plus uses a wooden dowel of 25.4mm or 1" in diameter. I already had some laying around so I put it to good use. You can find these dowels at your nearest home improvement store (Home Depot, Lowe's, etc for USA). I cut them at 11 inches since it gives the best clearance for most of my helmets but you can always cut it to your desired length, I can't tell you what to do. I hope you enjoy this model as I worked really hard on it (no I didn't, it was easy 123). Please leave a like and subs… sorry wrong place. Alright, see ya!