Thingiverse
Countersink Pelican Box
von sej7278
29
Downloads
26
Likes
0
Makes
I remixed as I had a different set of countersinks from China: https://www.aliexpress.com/item/4000050405050.html
I found that the hinge is a bit brittle (too tight) and the latch is too.
Included Fusion360 source and an STL with some embossed text that I didn't print.
I was going to add some magnets to keep the bits in place but the hex fit is tight enough and the inner height just about right that its not needed.
I found that the hinge is a bit brittle (too tight) and the latch is too.
Included Fusion360 source and an STL with some embossed text that I didn't print.
I was going to add some magnets to keep the bits in place but the hex fit is tight enough and the inner height just about right that its not needed.
sej7278 veröffentlicht auch auf
27 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
