Thingiverse
Covered Filament Spool Holder - Version 2
por pfiesm
100
Descargas
68
Likes
2
Makes
This spool holder is intended to be somewhat air tight to prevent moisture absorption. The spool holder itself is this one which uses bearings and has a nice size plate on the mounting end. This helps with the seal on the case.
The original version of this was printed with clear filament in vase mode. This worked for a while, but I found the vase mode to not be strong enough and the edge of the cover broke off. So this version is made to print in normal mode and with stronger walls.
The cover has some flat spots on the sides. The one on the bottom can hold a desiccant bag. The one on the side is to allow mounting a Bowden tube coupler. This coupler works pretty well. The backing plate provided will allow you to sandwich the spool cover between the coupler and the backing plate. Use some M3 screws and nuts to put it together.
There are also a few window openings so you can see how much filament is left on the spool. The one pictured has only one window, but I added a couple
The original version of this was printed with clear filament in vase mode. This worked for a while, but I found the vase mode to not be strong enough and the edge of the cover broke off. So this version is made to print in normal mode and with stronger walls.
The cover has some flat spots on the sides. The one on the bottom can hold a desiccant bag. The one on the side is to allow mounting a Bowden tube coupler. This coupler works pretty well. The backing plate provided will allow you to sandwich the spool cover between the coupler and the backing plate. Use some M3 screws and nuts to put it together.
There are also a few window openings so you can see how much filament is left on the spool. The one pictured has only one window, but I added a couple
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
