Thingiverse
Covid-19 Eye Shield
door cabuu
7
Downloads
4
Likes
0
Makes
Following on from my face shield (https://www.thingiverse.com/thing:4251293). I have made a protective eye shield.
Simply cut a short (approx 65mm) length of an A4 PVC sheet and punch 4 holes using an international 2 hole punch. 2 holes using the A4 setting and 1 on each side using the 0 setting.
I recommend u sing PVC of between 200-300 microns, binder covers work perfectly and I have included a link to the ones I am using below.
Clear PVC:
https://amzn.to/2UH0tJG
https://amzn.to/2URMGQE
https://amzn.to/2ULGdYC
Make sure you take appropriate precautions before using, this is a prototype and should only be used as a last resort, I can make no claim to the efficacy of this product as a medical device or use for PPE.
Simply cut a short (approx 65mm) length of an A4 PVC sheet and punch 4 holes using an international 2 hole punch. 2 holes using the A4 setting and 1 on each side using the 0 setting.
I recommend u sing PVC of between 200-300 microns, binder covers work perfectly and I have included a link to the ones I am using below.
Clear PVC:
https://amzn.to/2UH0tJG
https://amzn.to/2URMGQE
https://amzn.to/2ULGdYC
Make sure you take appropriate precautions before using, this is a prototype and should only be used as a last resort, I can make no claim to the efficacy of this product as a medical device or use for PPE.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
