Thingiverse
Covid-19 Face shield for small printer.
por kevin_clyne
24
Descargas
29
Likes
0
Makes
Based on the design of 3DVERKSTAN.
Divided in half to fit on a 6"x 6" print bed.
small amount of trimming on the two part that slides together, just to remove supports.
for the clear part
Office Depot Item 459-207
Must be GLOSSY CLEAR.
Use a US standard 3-hole punch, punch long edge in the center then move the sheet left or right in the hole puncher until previous holes are centered between the punchers pins and punch again.
Divided in half to fit on a 6"x 6" print bed.
small amount of trimming on the two part that slides together, just to remove supports.
for the clear part
Office Depot Item 459-207
Must be GLOSSY CLEAR.
Use a US standard 3-hole punch, punch long edge in the center then move the sheet left or right in the hole puncher until previous holes are centered between the punchers pins and punch again.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
