Thingiverse

Covid-19 Face Shield

by david115599

8 Downloads

11 Likes

0 Makes

!!!!Rotate File to be flat on bed

V3 Updates:
The model is now slightly faster to print and is more durable as well as stack separation is much easier.
This has been achieved by removing the extra arms and going back to a design closer to the 3D Verk design.

Assembly Instructions: https://youtu.be/g1mQ075N6h8

The spacer files are used to get accurate hole spacing in the transparency films when they are hole punched.

This face shield design uses two sets of hole punches to hold a transparency film, or any other clear plastic, to the frame. This shield is a hybrid remix of the Prusa Rc3 https://www.prusaprinters.org/prints/25857-prusa-protective-face-shield-rc2 and the https://3dverkstan.se/protective-visor/ shields incorperating the best elements from both based on feedback from doctors currently using them.

Improvments from RC3:

Top section covered to prevent droplets from entering from above
Faster to print and takes less material
Transparency rettenion system

COVID19 NoTouchChallenge combat coronavirus coronavirus coronavirus defend Coronavirus Face Mask face shield hackthepandemic ppe prusa stepper COVID19 NoTouchChallenge combat coronavirus coronavirus coronavirus defend Coronavirus Face Mask face shield hackthepandemic ppe prusa stepper

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format