COVID-19 Face Shield

I created this version after using the Sweden version for a while. It worked great but had a few small things some of the doctors mentioned could be improved on. After many revisions and testing this was the version that everyone loved. It uses the exact same spacing as the Sweden version for punching the holes with a 3 hole punch in the transparency sheet. Rather then explain how to make the face shields with the hole punch here is the link from the original version. https://3dverkstan.se/protective-visor/protective-visor-versions/

Print these at whatever layer height you want but make sure your layer width is .50mm and set 5 shells or perimeters depending on your slicer. No infill is needed!

I've added a gcode to print 3 of them on the Eryone Thinker-S also works well on my CR10 and probably any other 300x300 printer. It prints at 100mm/s so if your printer doesnt like it just turn the feedrate down to 80%

Just added a version with no raise on the top for faster printing, it