Thingiverse
Covid Mask Dryer
von ruben02
6
Downloads
4
Likes
0
Makes
I've designed this mask holder to be easier to dry the Covid facemasks, after washing them on the washing machine at 60º degrees.
This support goes over my dehumidifier and with this length allows to dry 3 masks at the same time.
WARNING: Allways check if your mask is washable and the maximum number of washes.
NOT to be used with cirurgical masks !
You have to print 2 supports and need 5 aluminum rods with 6mm diameter. The rods lenght is your decision. I've made my rods with 50cm length.
This support goes over my dehumidifier and with this length allows to dry 3 masks at the same time.
WARNING: Allways check if your mask is washable and the maximum number of washes.
NOT to be used with cirurgical masks !
You have to print 2 supports and need 5 aluminum rods with 6mm diameter. The rods lenght is your decision. I've made my rods with 50cm length.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
