Thingiverse
COVID Mask Modified
von Cjm09075
28
Downloads
21
Likes
0
Makes
Print the mask then assemble a HEPA or home AC filter cut into the mask cap, screw in the holder and fill the gap with hot glue (a little on the threads would be good as well). Screw in tight. Mask should create suction when breathing in and hole plugged with hand. can hot glue window strip, other foam or strip of towel around part that contacts the face if needed.
Mask was not my design but the replaceable filter is
PLA no supports needed
Stay safe!!!
This is untested and should be used as a last resort only
Mask was not my design but the replaceable filter is
PLA no supports needed
Stay safe!!!
This is untested and should be used as a last resort only
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
