Cowabunga! Foam Dart Blaster

This is Cowabunga! A Foam blaster designed for short dart (Talon) systems. The key feature of this design is the fact that it uses a smaller solenoid than most other solenoid builds. The Solenoid I designed this around is about half the size of the 35mm ones that are currently popular, but it functions exactly as needed (at only 15mm stroke). You can get the hardware directly from my etsy:

https://www.etsy.com/shop/RadBlasters/

Other than that feature, this is basically a primary blaster crammed into the smallest form factor I could create. Fully built, this can get 130-140 FPS on 4x Honeybadger motors...and it can be select fire too!

So if you are reading this, I bet you are anxious to start printing. Here is a guide for every part and how I currently print them:

Top Receiver - This is the main piece of the blaster. I print it upside down so that the Top of the receiver is on the build plate. I add enough support to ensure the area that slopes behind the stock attachment i