Thingiverse
CP2102 case
door franjo_zilic
2
Downloads
0
Likes
0
Makes
Simple protective case for CP2102 UART adapter board made by e-radionica https://e-radionica.com/en/usb-uart-adapter-with-cp2102-made-by-e-radionica.html
Print in what ever material you have at hand, anything will work.
Board does not have symmetrical holes, and case is designed to allow easy access to all pin headers, USB port and somewhat simple access to voltage switch while protecting them from accidental shorts
Case is designed with enough tolerance to make it printable on almost any printer.
Keep in mind, only alignment notches are designed, not a snap case design, use glue for final assembly.
Since part is quick and cheap to print, snap design was not even considered.
Print in what ever material you have at hand, anything will work.
Board does not have symmetrical holes, and case is designed to allow easy access to all pin headers, USB port and somewhat simple access to voltage switch while protecting them from accidental shorts
Case is designed with enough tolerance to make it printable on almost any printer.
Keep in mind, only alignment notches are designed, not a snap case design, use glue for final assembly.
Since part is quick and cheap to print, snap design was not even considered.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
