Thingiverse
CR-10 Auto Bed Level Test
door 3DPrintingArtDesigns
3
Downloads
4
Likes
0
Makes
Clean the printer bed with rubbing alcohol to ensure good adhesion.
Run the auto bed level with a sheet of paper and ensure that the nozzle grips the piece of paper.
Then print this test and manually adjust as it prints. If you have loose filament just remove it from the printer bed and leave it printing while you get it leveled.
Cheers,
Run the auto bed level with a sheet of paper and ensure that the nozzle grips the piece of paper.
Then print this test and manually adjust as it prints. If you have loose filament just remove it from the printer bed and leave it printing while you get it leveled.
Cheers,
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!