CR 10 electronic box support

Support for the electronic box of the CR 10 V3 in order to provide ventilation for the power supply and thus facilitate the evacuation of heat inside the electronic box.

Designed and tested on the CR 10 V3

It works on all models of the CR 10 or similar. The width is 125.30mm (about 12.5cm). It could work on others.

I would appreciate a positive review

Note: If you have problems when printing, print it by rotating the piece 90º and reduce the support as much as possible (see 3D printing parameters) in case of warping because the legs are very narrow and the first layers will probably come off .